Ford Mustang (1999-2004) Service Manual: Ignition Switch Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch drift, press the ignition switch lock cylinder release pin through the access hole while pulling out the ignition switch lock cylinder.
3. To install, reverse the removal procedure.
- Verify ignition switch lock cylinder operation.
Ignition Switch Lock Cylinder - Non-Functional
Removal and Installation 1. NOTE: Make sure the front wheels are in the straight-ahead position. Disconnect the battery ground cable (14301) and wait at least one minute to allow the depletion of t ...Other materials:
Anti-Theft - Passive Anti-Theft System (PATS) (Description and Operation)
The passive anti-theft system (PATS) contains the following components:
theft indicator
encoded ignition key
transceiver module
instrument cluster
powertrain control module (PCM)
standard corporate protocol (SCP) communication network
The PATS uses rad ...
Extension Housing
Special Tool(s)
Installer, Bearing Cup
204-039 (T77F-1217-B)
Adapter for 303-224 (Handle)
205-153 (T80T-4000-W)
Disassembly and Assembly
1. Remove the bolt and the output shaft speed (OSS) sensor.
2. Remove the bolt a ...
Air Bag Disposal - Passenger, Undeployed, Scrapped
Vehicle
Remote Deployment
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module or safety belt
retractor/pretensioner assembly. This will reduce the risk of injury in
t ...