Ford Mustang (1999-2004) Service Manual: Index Card
Place an index card or a piece of paper between the weatherstrip and the sealing surface, then close the door. Slowly withdraw the index card or paper after the door is closed and check the amount of pressure on the weatherstrip. There should be a medium amount of resistance as it is withdrawn.
Continue around the entire seal area. If there is little or no resistance, this indicates insufficient contact to form a good seal. At these points, the door, the glass, or the weatherstrip is out of alignment.
Tracing Powder
Tracing powder is used to check both the uniformity of contact and the tension of a seal against its sealing surface. These tests are usually done when a suspected air leak/noise appears to originat ...Noise, Vibration and Harshness (NVH) (Diagnosis and Testing)
Special Tool(s) ChassisEAR 107-R2102 or equivalent Electronic Vibration Analyzer 100-F027 (014-00344) or equivalent EngineEAR 107-R2100 or equivalent ...Other materials:
Lower Arm
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number must be installed if installation becomes nec ...
Air Distribution
NOTE: The air distribution system of this vehicle cannot be equipped
with a cabin air filter.
There are two sources of air available to the air distribution system:
outside air
recirculated air
Recirculated air is only used during MAX A/C.
Air distribut ...
Pinpoint Tests - OSC Equipped Vehicles
Special Tool(s)
Breakout Box, EEC-V Control
System
418-049 (T94L-50-EEC-V) or
equivalent
MLP-TR Cable
418-F107 (007-00111) or
equivalent
Worldwide Diagnostic System
(WDS)
418-F224
New Generation STAR (NGS)
T ...