Ford Mustang (1999-2004) Service Manual: Installation
1. Install the upper arm and bushing to the mounting bracket.
1. Position the arm and bushing.
2. Install a new nut and bolt. Do not tighten at this time.
2. Connect the upper arm and bushing to the axle.
1. Position the arm and bushing.
2. Install a new nut and bolt. Do not tighten at this time.
3. Raise the suspension until the shock absorber is compressed to the previously established alignment mark (curb height).
4. Tighten the arm and bushing-to-mounting bracket bolt.
5. Tighten the arm and bushing-to-axle bolt.
6. Lower the suspension and remove the jack stand.
7. Lower the vehicle.
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...Other materials:
Suction Accumulator to Compressor Line - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when
repairing the ...
Spring
Special Tool(s)
Tie-Rod End Remover
211-001 (TOOL-3290-D) or
Equivalent
Coil Spring Compressor
204-D001 (D78P-5310-A) or
Equivalent
...
Installation
1. NOTE: LH shown; RH similar.
Install the camshafts.
Lubricate the camshafts with clean engine oil.
2. Install the camshaft bearing cap assemblies and tighten the bolts in the
sequence shown.
3. Install the bolts.
4. CAUTION: Timing marks must be a ...