Ford Mustang (1999-2004) Service Manual: Oil Filter Adapter

Material

Item Specification
Super Premium SAE 5W-20 Motor Oil XO-5W20 QSP or equivalent WSS-M2C153- H
Premium Engine Coolant VC-4A (In Canada CXC-10; In Oregon VC-5) or equivalent ESE-M97B44- A

Removal and Installation

1. Drain the cooling system.

2. Disconnect the lower radiator hose.

Oil Filter Adapter

3. Raise and support the vehicle. For additional information, refer to Section.

4. Drain the engine oil.

Oil Filter Adapter

5. Disconnect the oil pressure sensor electrical connector.

Oil Filter Adapter

6. Remove the oil pressure sensor.

Oil Filter Adapter

7. Remove the oil filter adapter (6881).

1. Remove the oil bypass filter.

2. Remove the bolts.

3. Remove the oil filter adapter.

4. Clean and inspect the sealing surfaces.

Oil Filter Adapter

8. To install, reverse the removal procedure.

9. Tighten the oil pressure sensor in two stages.

  • Tighten to 14Nm(10 lb-ft).
  • Tighten an additional 180

Oil Filter Adapter

    Exhaust Manifold LH
    Special Tool(s) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Support Bar, Engine 303-290-A Removal and Installation 1. Install the special tool. 2. Install the speci ...

    Oil Level Indicator and Tube
    Removal and Installation 1. Remove the oil level indicator. 2. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold LH in this section. 3. Remove the bolt. 4. Rem ...

    Other materials:

    Changing a bulb
    Lamp Assembly Condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can oc ...

    Link - Stabilizer Bar
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes nec ...

    Hydraulic System
      Fluid Pump   The transmission uses a gerotor-type design front pump support and gear. The pump provides the volume of fluid needed to charge the torque converter, main control assembly, cooling system and lube system. Pump pressure is regu ...