Ford Mustang (1999-2004) Service Manual: Exhaust Manifold LH
Special Tool(s)
Lifting Bracket, Engine 303-D088 (D93P-6001-A2) | |
Support Bar, Engine 303-290-A |
Removal and Installation
1. Install the special tool.
2. Install the special tools.
3. Raise and support the vehicle. For additional information, refer to Section.
4. Remove the LH and RH side engine mount nuts.
5. Lower the vehicle.
6. Using the special tools, raise the engine.
7. Raise the vehicle.
8. Separate the exhaust at the exhaust manifold. For additional information, refer to Section.
9. Disconnect the exhaust gas recirculation (EGR) tube at the exhaust manifold.
10. Remove the exhaust manifold.
1. Remove the exhaust manifold nuts.
2. Remove the exhaust manifold.
3. Remove the exhaust manifold gasket.
11. To install, reverse the removal procedure.
1. Tighten the exhaust manifold nuts in the sequence shown.
Exhaust Manifold RH
Special Tool(s) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Support Bar, Engine 303-290-A Removal and Installation 1. Install the special tool. 2. Install the speci ...Oil Filter Adapter
Material Item Specification Super Premium SAE 5W-20 Motor Oil XO-5W20 QSP or equivalent WSS-M2C153- H Premium Engine Coolant VC-4A (In Canada CXC-10; In Oregon VC-5) or ...Other materials:
Muffler - 4.6L (4V)
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to
Section.
2. NOTE: RH side shown, LH side similar.
Remove the dual converter assembly nuts.
3. Remove the RH exhaust hanger insulator (5260).
4. Remove the LH ...
Suction Accumulator to Compressor Line - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when
repairing the ...
Installation
1. Install the bearing, snap ring, hub and dust shield. For additional
information, refer to Wheel
Hub-Cobra in this section.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do ...