Ford Mustang (1999-2004) Service Manual: Rear Ride Height Measurement - GT and Base

Rear Ride Height Measurement - GT and Base

Item Description
1 Body reinforcement
2 Ride height (shortest distance)
3 Rear axle

Wheel Track

Wheel Track

Item Part Number Description
1 - Front track
2 - Rear track

Dogtracking

Dogtracking

Item Part Number Description
1 - Vehicle centerline
2 - Axle centerline
3 - Thrust angle

Dogtracking or thrust angle is the condition in which the rear axle is not square to the chassis. Heavily crowned roads can give the illusion of dogtracking.

Wander

Wander is the tendency of the vehicle to require frequent, random left and right steering wheel (3600) corrections to maintain a straight path down a level road.

Shimmy

Shimmy, as observed by the driver, is large, consistent, rotational oscillations of the steering wheel resulting from large, side-to-side (lateral) tire/wheel movements.

Shimmy is usually experienced near 64 km/h (40 mph), and can begin or be amplified when the tire contacts pot holes or irregularities in the road surface.

Nibble

Sometimes confused with shimmy, nibble is a condition resulting from tire interaction with various road surfaces and observed by the driver as small rotational oscillations of the steering wheel.

Poor Returnability/Sticky Steering

Poor returnability and sticky steering is used to describe the poor return of the steering wheel to center after a turn or steering correction is completed.

Drift/Pull

Pull is a tugging sensation, felt in the steering wheel, that must be overcome to keep the vehicle going straight.

Drift describes what a vehicle with this condition does with hands off the steering wheel.

  • Drift/pull may be induced by conditions external to the vehicle (i.e., wind, road camber).

Poor Groove Feel

Poor groove feel is characterized by little or no buildup of turning effort felt in the steering wheel as the wheel is rocked slowly left and right within very small turns around center or straight-ahead (under 20 degrees of steering wheel turn). Efforts may be said to be "flat on center."

  • Under 20 degrees of turn, most of the turning effort that builds up comes from the mesh of gear teeth in the steering gear (3504). In this range, the steering wheel is not yet turned enough to feel the effort from the self-aligning forces at the road wheel or tire patch.
  • In the diagnosis of a handling problem, it is important to understand the difference between wander and poor groove feel.
    Negative and Positive Camber
    Camber is the vertical tilt of the wheel (1007) when viewed from the front. Camber can be positive or negative and has a direct effect on tire wear. Caster Item Part Number Description ...

    Other materials:

    Component Tests
    Starter Motor -Voltage Drop Test WARNING: When servicing starter motor or carrying out other underhood work in the vicinity of the starter motor, be aware that the heavy gauge battery input lead at the starter solenoid is "electrically hot" at all times. A p ...

    Engine block heater
    WARNING: Failure to follow engine block heater instructions could result in property damage or physical injury. WARNING: Do not use your heater with ungrounded electrical systems or two-pronged (cheater) adapters. There is a risk of electrical shock. Note: The ...

    Diagnostic Instructions - Air Bag Supplemental Restraint System (SRS)
    Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool The symptom chart can be used to help locate the air bag supplemental restraint system (SRS) concerns if n ...