Ford Mustang (1999-2004) Service Manual: Rear Wheel Bearing and Axle Shaft Oil Seal
Special Tool(s)
Adapter for 303-224 205-153 (T80T-4000-W) | |
Installer, Axle Shaft Bearing 205-124 (T78P-1225-A) | |
Installer, Rear Axle Oil Seal 205-390 (T97T-1177-B) | |
Remover, Axle Bearing 205-219 (T85L-1225-AH) | |
Slide Hammer 100-001 (T50T-100-A) |
Removal
1. Remove the axle shaft (4234). For additional information, refer to Axle Shaft in this section.
2. NOTE: If the wheel bearing oil seal is leaking, the axle housing vent may be plugged.
Using the special tools, remove the rear wheel bearing and wheel bearing oil seal.
Installation
1. Lubricate the new rear wheel bearing with the specified lubricant.
2. Using the special tools, install the new rear wheel bearing.
3. Lubricate the lip of the new wheel bearing oil seal.
- Use Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESAM1C75- B.
4. Using the special tools, install the new wheel bearing oil seal.
5. Install the axle shaft. For additional information, refer to Axle Shaft in this section.
Other materials:
Key Release Button
Removal
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and
turn to RUN position.
2. Push the ignition switch lock cylinder release tab with a p ...
Pinpoint Tests
PINPOINT TEST A: THE ENGINE DOES NOT CRANK AND THE
RELAY DOES CLICK
Test Step
Result / Action to Take
A1 CHECK THE VOLTAGE TO THE STARTER RELAY
YesGO to A2 .
No
REPAIR circuit 1050 (LG/VT) for an open. TEST the
system for normal operation. ...
Noise, Vibration and Harshness (NVH) (Diagnosis and Testing)
Special Tool(s)
ChassisEAR
107-R2102 or equivalent
Electronic Vibration Analyzer
100-F027 (014-00344) or
equivalent
EngineEAR
107-R2100 or equivalent
Ultrasonic Leak Detector
134-R0135 or equivalent
T ...