Ford Mustang (1999-2004) Service Manual: Driveline
- Driveline System - General Information
- Driveline System
- Driveline Angle
- Gear Howl and Whine
- Driveline Angle Inspection
- Axle Housing Casting Porosity (Holes in Casting) Repair
- Driveshaft
- Driveshaft (Description and Operation)
- Universal Joints
- Driveshaft (Removal and Installation)
- Driveshaft - Cobra
- Driveshaft Slip Yoke
- Universal Joint - Single Cardan, Flange Yoke
- Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear
- Axle Shaft
- Drive Pinion Flange and Drive Pinion Seal
- Differential Housing Cover
- Axle Housing Bushing
- Drive Pinion
- Axle Assembly
- Differential Case and Ring Gear
- Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear
- Rear Drive Axle and Differential
- Rear Wheel Bearing and Axle Shaft Oil Seal
- Drive Pinion
- Differential Case
- Axle Housing
- Differential Case and Ring Gear - Conventional
- Differential Case and Ring Gear - Traction-Lok
- Rear Drive Axle/Differential - Ford 8.8-Inch IRS
- Rear Drive Axle and Differential
- Stub Shaft Pilot Bearing and Seal
- Drive Pinion Flange
- Pinion Seal
- Axle Housing
- Axle
- Rear Drive Halfshafts
Wheel And Tire
Removal
1. CAUTION: Do not use heat to loosen a seized wheel nut (1012). Heat
can damage
the wheel and wheel bearings.
NOTE: To avoid damage or scratching to the center cap, place facing up
when rem ...
Driveline System - General Information
Driveline Angles @ Curb Specifications
All driveshaft and pinion angles point downward.
General Specifications
a: Service refill capacities are determined by filling the axle 6.3 mm (0.25
in [1/4 ...
Other materials:
Removal
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assemblies.
3. CAUTION: Remove the rear brake calipers to prevent drag during the
drive pinion
bearing preload adjustment.
CAUTION: Do not allow the calipers to hang from the brake hoses ...
Removal
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module. This will
reduce the risk of injury
in the event of an accidental deployment.
WARNING: Carry a live air ...
Belt Minder Deactivating/Activating
Preparation
1. Before deactivating/activating the belt minder, set the parking
brake.
2. Place the gearshift in P (Park) (automatic transmission) or the
neutral position (manual
transmission).
3. Place the ignition switch in the OFF position.
...
