Ford Mustang (1999-2004) Service Manual: Support Straps

Removal

WARNING: Do not smoke, carry lighted tobacco or an open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited, possibly resulting in personal injury.

WARNING: Fuel supply lines on all vehicles equipped with fuel injected engines will remain pressurized for long periods of time after engine shutdown. Fuel system pressure must be relieved prior to fuel system service to prevent possible personal injury or a fire hazard.

1. Remove the fuel tank. For additional information, refer to Fuel Tank in this section.

2. Slide the strap and the retaining pin into the recess and remove the strap retaining pin.

Support Straps

3. Remove the strap.

Installation

1. To install, reverse the removal procedure.

    Installation
    1. CAUTION: Lubricate the filler pipe check valve area and the tank-to-filler pipe grommet with Serfactant prior to assembly or damage to the filler pipe check valve will occur. NOTE: A new grommet ...

    Fuel Pump Module
    Removal and Installation 1. Remove the fuel tank. For additional information, refer to Fuel Tank in this section. 2. NOTE: For installation, tighten the bolts in the sequence shown. Remove the modu ...

    Other materials:

    Fittings - Vapor Tube
    Disconnect 1. WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimiz ...

    Pinpoint Test H: LFC 32/DTC B1932 - Driver Air Bag Circuit Resistance High
    Normal Operation The restraints control module (RCM) monitors the resistance for the driver air bag ignitor by measuring the resistance between pins 3 and 4. If the RCM detects high resistance between these pins, it will store a diagnostic trouble code ...

    Throttle Body
    Removal WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions can result in personal in ...