Ford Mustang (1999-2004) Service Manual: Switch - Deactivator
Removal
1. Disconnect the battery ground cable.
2. Remove the deactivator switch.
1. Disconnect the deactivator switch electrical connector.
2. Detach the lower deactivator switch hook.
3. Detach the upper deactivator pivot.
Installation
1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
To install, reverse the removal procedure.
- Adjust the deactivator switch, refer to Switch Adjustment-Deactivator
Actuator - Speed Control Servo
1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result. Disconnect the battery ground cable. 2. Remove the LH wheel and tire; re ...Switch - Speed Control Actuator
Removal 1. Remove the steering wheel; refer to Section. 2. Remove the steering wheel rear cover. 1. Remove the screws. 2. Remove the steering wheel rear cover. 3. Remove the ribbon harne ...Other materials:
Pinpoint Tests - OSC Equipped Vehicles
Special Tool(s)
Breakout Box, EEC-V Control
System
418-049 (T94L-50-EEC-V) or
equivalent
MLP-TR Cable
418-F107 (007-00111) or
equivalent
Worldwide Diagnostic System
(WDS)
418-F224
New Generation STAR (NGS)
T ...
Adjusting the headlamps
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, an authorized dealer should
check the alignment of your headlamps.
Vertical Aim Adjustment
1. Park the vehicle directly in front of a wall or scre ...
Heater Hose Coupling
Special Tool(s)
Remover, Heater Hose Inlet
Tube
412-042 (T85T-18539-AH)
Disconnect Tool, Heater Hose
412-127
Material
Item
Specification
MERPOL
-
ESE-M99B144-B
Disconnect
CAUTION: Do not attempt to install a ...