Ford Mustang (1999-2004) Service Manual: Switch - Traction Control
Removal and Installation
1. NOTE: If the vehicle is equipped with an automatic transmission, position the shift lever in the 1 position before detaching the floor console finish panel.
Lifting from both sides, detach the floor console finish panel.
2. Disconnect the electrical connector and position the finish panel out of the way.
3. Reaching behind the center finish panel, push and detach the switch from the finish panel.
4. Disconnect the electrical connector and remove the switch.
5. To install, reverse the removal procedure.
Sensor - Rear
Removal 1. Remove the rear passenger seat. 2. Disconnect the rear anti-lock brake sensor electrical connector. 3. Raise and support the vehicle. 4. Remove the rear anti-lock brake sensor harne ...Steering System
...Other materials:
Fluid Pan, Gasket and Filter
Material
Item
Specification
MERCON V Automatic
Transmission Fluid
XT-5-QM, XT-5-DM
MERCON V
1. Normal maintenance requires periodic automatic transmission fluid changes.
If a major repair,
such as a clutch, band, bearing, etc., is requir ...
Door
Removal
1. Remove the door trim panel. For additional information, refer to
Section.
2. Disconnect the necessary electrical connectors to remove the harness
and grommet from the
door.
3. NOTE: This procedure requires an assistant.
NOTE: Mark ...
Vacuum Control Motor - Air Inlet Duct Door
Removal
1. Remove the instrument panel.
2. Disconnect the vacuum hose.
3. Disconnect the control arm.
4. Remove the vacuum control motor.
Remove the screws.
Installation
1. To install, reverse the removal procedure. ...