Ford Mustang (2005-2014) Owners Manual: Washer fluid check

WARNING: If you operate your vehicle in temperatures below 40°F (5°C), use washer fluid with antifreeze protection. Failure to use washer fluid with antifreeze protection in cold weather could result in impaired windshield vision and increase the risk of injury or accident.

Add fluid to fill the reservoir if the level is low. Only use a washer fluid that meets Ford specifications. See the technical specifications chart in the Capacities and Specifications chapter.

State or local regulations on volatile organic compounds may restrict the use of methanol, a common windshield washer antifreeze additive.

Washer fluids containing non-methanol antifreeze agents should be used only if they provide cold weather protection without damaging the vehicle’s paint finish, wiper blades or washer system.

    Fuel filter
    Your vehicle is equipped with a lifetime fuel filter that is integrated with the fuel tank. Regular maintenance or replacement is not needed. For Shelby fuel filter requirements, see the Shelby GT500 ...

    Changing the vehicle battery
    WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery. When working near the batter ...

    Other materials:

    Disassembly
    1. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate serrations for scores or burrs. Minor scores or burrs may be removed with crocus cloth. Install a new clutch cylinder if it is badly scored or damaged. 2. Check the fluid passage i ...

    Starting a gasoline engine
    When you start the engine, the idle speed increases, this helps to warm up the engine. If the engine idle speed does not slow down automatically, have your vehicle checked by an authorized dealer. Before starting the engine: • Make sure all occupants have f ...

    Installation
    1. Install the intake manifold and gaskets, tighten the bolts in the sequence shown. 2. NOTE: The O-ring is to be installed on the top of the thermostat. Install the water thermostat and the O-ring. Install a new O-ring as necessary. 3. Install the wa ...