Ford Mustang (1999-2004) Service Manual: Accessory Drive (Diagnosis and Testing)

Accessory Drive - Cobra

Component Locations -Supercharger Accessory Drive   Component Location -Accessory Drive   ...

Inspection and Verification

1. Verify customer concern by running the engine. 2. Inspect the drive belt for chunking, fraying and wear. 3. Check the drive belt for correct routing. Drive Belt Cracking/Chunking/Wear V Ribbed Se ...

Other materials:

Connecting Rod - Side Clearance
1. Measure the clearance between the connecting rod and the crankshaft. Verify the measurement is within specification. Refer to the appropriate section in Group for the procedure. If out of specification, install new components as necessary. Refer ...

Driveshaft (Removal and Installation)
Material Item Specification Threadlock and Sealer E0AZ-19554-AA WSK-M2G351-A5 (type II) Removal and Installation 1. Raise and support the vehicle. 2. Carry out the following: 1. Place an index mark on the rear axle pinion flange and ...

Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the brake master cylinder (2140). The hydro-boost bleed screw, located near the dash on the hydro-booster casting, is for the booster cavity filled with power steering fluid, not brake fluid. ...