Ford Mustang (1999-2004) Service Manual: Bleeding - System

Caliper

1. NOTE: It is not necessary to do a complete brake system bleed if only the disc brake caliper (2B120) was disconnected. Place a box end wrench on the disc brake caliper bleeder screw (2208). ...

Manual

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water fo ...

Other materials:

Switch
Removal 1. Remove the climate control assembly. For additional information, refer to Control Assembly in this section. 2. NOTE: All three switches are removed the same. Remove the knob. 3. Remove the screw. 4. Rotate the switch and remove it from the cont ...

Idle Air Control (IAC) Valve - Mach I
Removal and Installation 1. Remove the air intake scoop. For additional information, refer to Section. 2. Disconnect the idle air control (IAC) valve electrical connector. 3. Remove the bolts, the IAC valve and the gasket. 4. NOTE: Install a new ga ...

Torque Converter Turbine to Pump Stator Interference Check
1. NOTE: Front pump support may remain in front pump support and gear during this test. Position the torque converter with the pump drive up. 2. Install the front pump support to engage the mating splines of the front pump support shaft on the torque convert ...