Ford Mustang (1999-2004) Service Manual: Brake System - General Information
Torque Specifications
- Brake System (Description and Operation)
- Brake System (Diagnosis and Testing)
- Bleeding - Components
- Bleeding - System
- Runout Check - Brake Disc and Hub
Brake System
...
Brake System (Description and Operation)
Component Locations
+
The vehicle is equipped with a vacuum-assisted or a hydro-boost power braking
system.
The braking system is a front-to-rear split hydraulic system.
The front wheel b ...
Other materials:
Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the
brake master cylinder
(2140). The hydro-boost bleed screw, located near the dash on the
hydro-booster
casting, is for the booster cavity filled with power steering fluid, not
brake fluid. ...
Four Wheel Anti-Lock Brake System (4WABS) Hydraulic Control Unit (HCU)
NOTE: This procedure only needs to be performed if the 4-wheel
anti-lock brake (4WABS) hydraulic
control unit (HCU) has been installed new or if the HCU lines have been
opened.
1. Clean all dirt from and remove the brake master cylinder filler cap
...
Front Bumper Cover
Removal and Installation
NOTE: Mustang shown, GT and Cobra similar.
1. Remove the pin-type retainers and the radiator upper sight shield.
2. Remove the two pin-type retainers (one each side).
3. Remove the four front bumper cover nuts (two each side).
4. ...
