Ford Mustang Owners Manual: Brake and clutch fluid check

Brake and clutch (if equipped) systems are supplied from the same reservoir.

Fluid levels between the MIN and MAX lines are within the normal operating range; there is no need to add fluid. If the fluid levels are outside of the normal operating range, the performance of the system could be compromised; seek service from your authorized dealer immediately.

    Transmission fluid check
    Checking Automatic Transmission Fluid Note: Transmission fluid should be checked and, if required, added by an authorized dealer. The automatic transmission does not have a transmission fluid dips ...

    Power steering fluid check
    Your vehicle is equipped with an electric power steering (EPS) system. There is no fluid reservoir to check or fill. For additional information on the electric power steering (EPS) system, Refer to ...

    Other materials:

    Assembly
    Disassembly 1. NOTE: The index mark on the output shaft must be aligned with the index mark on the output shaft ring gear during the assembly procedure. Remove the ring gear snap ring. 2. Separate the ring gear and output shaft. 3. Remove the three output ...

    Assembly
    Disassembly Initial disassembly 1. Remove the differential housing cover (4033) and drain the lubricant into a suitable container. 2. Wipe the lubricant from the internal working parts and inspect the parts for wear and damage. 3. Using the special tool, m ...

    Arm - Lower
    Wheel Studs Removal 1. Remove the wheel hub (1104). For additional information, refer to Wheel Hub and Bearing in this section. 2. Using a press, remove the wheel stud (1107) from the wheel hub. Installation 1. Using a press, install a new wheel stud. 2. I ...