Ford Mustang (2005-2014) Owners Manual: Maintenance
- General information
- Opening and closing the hood
- Under hood overview
- Engine oil dipstick
- Engine oil check
- Engine coolant check
- Transmission fluid check
- Brake and clutch fluid check
- Power steering fluid check
- Fuel filter
- Washer fluid check
- Changing the vehicle battery
- Checking the wiper blades
- Changing the wiper blades
- Air filter check
- Adjusting the headlamps
- Changing a bulb
- Bulb specification chart
Fuse specification chart
Power Distribution Box
WARNING: Always disconnect the battery before servicing high
current fuses.
WARNING: To reduce risk of electrical shock, always replace
the cover to the power distribution box b ...
General information
Have your vehicle serviced regularly to help maintain its roadworthiness
and resale value. There is a large network of Ford authorized dealers
who are there to help you with their professional servici ...
Other materials:
Overdrive Servo
Special Tool(s)
Remover/Installer, Servo
Piston
307-251 (T92P-70023-A)
Removal
1. Remove the main control valve body. For additional information, refer
to Main Control Valve
Body in this section.
2. NOTE: If the tool is not available, e ...
Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts.
Install a new driveshaft bearing retainer circlip.
2. Remove the special tool.
3. CAUTION: Differential seal damage will occur if installing the
halfshaft without the
special tool installed. ...
Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information
refer to Section.
2. Disconnect the cylinder head temperature sensor connector.
3. Remove the CHT sensor.
Installation
1. To install, reverse the removal procedure. ...
