Ford Mustang (1999-2004) Service Manual: Door
Removal
1. Remove the door trim panel. For additional information, refer to Section.
2. Disconnect the necessary electrical connectors to remove the harness and grommet from the door.
3. NOTE: This procedure requires an assistant.
NOTE: Mark the location of the door hinge on the door.
Remove bolts and the door.
Installation
1. To install, reverse the removal procedure.
Striker Adjustment
NOTE: After adjusting the door latch striker plate, verify that the
door can be closed easily and fits
tightly.
1. Loosen the door latch striker plate bolts.
2. Reposition the door latch str ...
Luggage Compartment Lid - Hinge
Removal
1. Disconnect the electrical connector.
2. Remove the lift cylinder.
3. Remove the luggage compartment lid hinge bolts.
4. NOTE: Remove the sealer around the luggage compartment lid hi ...
Other materials:
Pressure Plate Check
1. Check the clutch pressure plate surface for scoring, cracks or
discoloration. Minor scratches or
discoloration should be removed with a fine emery cloth.
2. Measure the flatness of the clutch pressure plate surface with a
straightedge and a feeler
g ...
Evaporative Emission Repair Verification Drive Cycle
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent scan
tool
Drive Cycle Recommendations
NOTE: The following procedure is designed to execute and
complete the evap ...
Crankshaft Front Seal
Special Tool(s)
Installer, Front Cover Oil Seal
303-335 (T88T-6701-A)
Installer, Crankshaft Front Oil
Seal
303-474 (T94P-6701-AH)
Remover, Oil Seal
303-409 (T92C-6700-CH)
Material
Removal
1. Remove the crankshaft pulley. ...
