Ford Mustang (1999-2004) Service Manual: Body Closures
General Specifications
Torque Specifications
Body Closures
The body closures consist of the following components:
- door checks
- front door
- front door latch strikers
- front door hinges
- front door opening weatherstrips
- hood
- hood (Cobra) with heat extractor scoops
- hood (Mach I) with shaker opening
- hood heat extractor scoops (Cobra)
- hood hinges
- hood support rod
- hood weatherstrip
- luggage compartment lid
- luggage compartment lid hinges
- luggage compartment lid hydraulic lifts
- luggage compartment lid latch striker
- luggage compartment lid weatherstrip
Front End Body Panels
Torque Specifications
Front End Body Panels
The front end body panel components consist of the following:
air deflectors
cowl grille
fenders
fender splash shields
hood
hood hi ...
Hinge Adjustment
NOTE: The door should be adjusted for even and parallel fit with the
body opening and surrounding
panels as well as making sure that the anti-chuck pin is not binding on
convertible models.
...
Other materials:
Supercharger Cooling System Draining, Filling and
Bleeding
Draining
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid having scalding hot ...
Vacuum Hose Repair - Mini-Tube
Special Tool(s)
Vacuum Pump Kit
416-D002 (D95L-7559-A) or
equivalent
1. Measure the length of the damaged area of the mini-tube vacuum hose.
2. Cut a piece of standard 1/8 inch inner diameter vacuum hose approximately 25
mm (1 inch
longer t ...
Fuel Pump Module
Removal and Installation
1. Remove the fuel tank. For additional information, refer to Fuel Tank in
this section.
2. NOTE: For installation, tighten the bolts in the sequence shown.
Remove the module assembly flange bolts.
3. Clean the area around the fue ...
