Ford Mustang (1999-2004) Service Manual: Driveline System - General Information
Driveline Angles @ Curb Specifications

All driveshaft and pinion angles point downward.
General Specifications

a: Service refill capacities are determined by filling the axle 6.3 mm (0.25 in [1/4 in]) to 14.3 mm (0.57 in [5/16 in]) below the bottom of the filler hole. The vehicle must be on a level surface.
b: Friction Modifier
- Driveline System
- Driveline Angle
- Gear Howl and Whine
- Driveline Angle Inspection
- Axle Housing Casting Porosity (Holes in Casting) Repair
Driveline
...
Driveline System
Special Tool(s)
Clamp Plate
205-320 (T92L-4851-C)
Clutch Housing Alignment
Adapter
308-021 (T75L-4201-A)
Companion Flange Holding
Tool
205-126 (T78P-4851-A ...
Other materials:
Support Straps
Removal
WARNING: Do not smoke, carry lighted tobacco or an open flame of any
type when
working on or near any fuel-related components. Highly flammable mixtures are
always present
and may be ignited, possibly resulting in personal injury.
WARNING: Fuel suppl ...
Ignition Switch Lock Cylinder - Non-Functional
Removal and Installation
1. NOTE: Make sure the front wheels are in the straight-ahead
position.
Disconnect the battery ground cable (14301) and wait at least one minute to
allow the depletion
of the restraint system backup power supply.
2. WARNING: To avo ...
Brake Pads - Cobra
Removal
1. Remove brake fluid in the master cylinder reservoir until the
reservoir is half full.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.
4. CAUTION: Install new pads if worn to or past the specified
thi ...
