Ford Mustang (1999-2004) Service Manual: Exterior Trim and Ornamentation
Torque Specifications
Exterior Trim and Ornamentation
The exterior trim and ornamentation consists of the following components:
- body side scoop
- hood scoop (if equipped)
- front spoiler (Mach 1)
- radiator grille
- rear spoiler (if equipped)
- rocker panel moulding
- roof side moulding
Radiator Grille
Removal and Installation
1. Remove the front bumper cover. For additional information, refer to Section.
2. Remove the screws and the radiator grille.
3. To install, reverse the removal procedure.
Headliner
Removal
1. Remove the two upper quarter panels. For additional information,
refer to Trim Panel-Upper
Quarter in this section.
2. Remove the two windshield side garnish mouldings.
3. Remov ...
Moulding - Roof Side
Removal and Installation
1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws.
4. Remove the roof side moulding screw. ...
Other materials:
Torque Converter Turbine to Pump Stator Interference
Check
1. NOTE: Front pump support may remain in front pump support and gear
during this test.
Position the torque converter with the pump drive up.
2. Install the front pump support to engage the mating splines of the front
pump support shaft on
the torque convert ...
Exhaust Manifold RH
Removal and Installation
1. Disconnect the battery negative cable. For additional information,
refer to Section.
2. Remove the air cleaner outlet pipe. For additional information, refer to
Section.
3. Disconnect the differential pressure feedback exha ...
Compressor Manifold and Tube Assembly - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when
repairing the ...
