Ford Mustang (1999-2004) Service Manual: Flexplate
Removal and Installation
1. Remove the transmission. For additional information, refer to Section.
2. Remove the six bolts retaining the flexplate to crankshaft, and remove the flexplate.
3. To install, reverse the removal procedure.
- Tighten the bolts in the sequence shown
Flywheel
Removal
1. Remove the clutch components.
2. Remove the bolts and the flywheel.
Installation
1. To install, reverse the removal procedure.
Tighten the bolts in the sequence shown.
...
Other materials:
Assembly
1. NOTE: Universal joint service kits are to be installed as complete
assemblies only. Do not mix
components from other U-joint kits.
Install the bearing cup.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct po ...
Wipers and Washers
General Specifications
Torque Specifications
Wipers and Washers
The wiper and washer system consists of the following components:
windshield wiper mounting arm and pivot shaft
pivot arms
windshield wiper blades
windshield washer reservoir
...
Principles of Operation
Evaporative Emission (EVAP) Canister Purge Valve
The EVAP canister purge valve is controlled by the powertrain control
module (PCM). The EVAP
canister purge valve controls the flow of fuel vapors from the EVAP canister
to the engine intake
manifold duri ...
