Ford Mustang (2005-2014) Owners Manual: Hazard warning flashers

The hazard flasher control is located on the center console next to the gearshift lever. Use it when your vehicle is disabled and is creating a safety hazard for other motorists.

• Press the flasher control and all front and rear direction signals will flash.
• Press the flasher control again to turn them off.

Note: With extended use, the flasher may run down your battery.

    Roadside assistance
    Vehicles Sold in the U.S.: Getting Roadside Assistance To fully assist you should you have a vehicle concern, Ford Motor Company offers a complimentary roadside assistance program. This program is se ...

    Fuel cut-off switch
    WARNING: Failure to inspect and if necessary repair fuel leaks after a collision may increase the risk of fire and serious injury. Ford Motor Company recommends that the fuel system be inspected by a ...

    Other materials:

    Instrument Cluster Replacement
    When it is necessary to install a new instrument cluster, contact the Instrument Cluster Program. Gauge Indication Systems Tachometer Engine rpm information is relayed to the instrument cluster from the powertrain control module (PCM) over the standard ...

    Cylinder Head Temperature (CHT) Sensor - 3.8L
    Removal 1. Disconnect the battery ground cable. For additional information refer to Section. 2. Disconnect the cylinder head temperature sensor connector. 3. Remove the CHT sensor. Installation 1. To install, reverse the removal procedure. ...

    Fuel Injection Supply Manifold and Fuel Injector
    Material Item Specification SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP WSS-M2C153- H Removal and Installation WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel relat ...