Ford Mustang (1999-2004) Service Manual: Hydraulic Lash Adjuster
Removal and Installation
1. Remove the roller followers. For additional information, refer to Camshaft Roller Follower in this section.
2. Remove the eight hydraulic lash adjusters.
3. Inspect the lash adjusters. For additional information, refer to Section.
4. To install, reverse the removal procedure.
Valve Seals
Special Tool(s)
Valve Spring Compressor
303-452 (T93P-6565-AR)
Valve Stem Seal Replacer
303-383 (T91P-6571-A)
Compressor, Valve Spring
(Exhaust)
303-567 (T97 ...
Camshaft Roller Follower
Special Tool(s)
Compressor, Valve Spring
(Intake)
303-452 (T93P-6565-AR)
Compressor, Valve Spring
(Exhaust)
303-567 (T97P-6565-AH)
Removal
1. Remove the valve cover. ...
Other materials:
Removal
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark before
tightening the
suspension component fasteners.
...
Inspection and Verification
NOTE: If any concerns are noted with the speedometer, stoplamps, or
horn, address those concerns
by referring to their associated sections before continuing speed control
diagnosis.
1. Verify the customer concern by operating the speed control system.
2. Vi ...
Stabilizer Bar - Cobra
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number must be installed if installation becomes nec ...
