Ford Mustang (1999-2004) Service Manual: Interior Trim and Ornamentation

General Specifications

General Specifications

Torque Specifications

Torque Specifications

Interior Trim

The interior trim consists of:

  • A-pillar lower trim panels
  • door trim panels
  • headliner (coupe)
  • package tray trim panel (coupe)
  • quarter trim panels
  • upper quarter trim panels (coupe)
  • scuff plates
  • sun visors
  • tether anchor covers (coupe)
  • windshield side garnish mouldings
Luggage Compartment Lid - Hinge
Removal 1. Disconnect the electrical connector. 2. Remove the lift cylinder. 3. Remove the luggage compartment lid hinge bolts. 4. NOTE: Remove the sealer around the luggage compartment lid hi ...

Trim Panel - Door
Removal All vehicles 1. CAUTION: Use a shop towel or similar material between the tool and the front door trim panel or damage to the front door trim panel may occur. Position the window re ...

Other materials:

Piston - Ring End Gap
CAUTION: Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore. CAUTION: Piston rings should not be transferred from one piston to another. NOTE: Cylinder bore must be within specification for taper and out-of ...

Installation
1. Clean the A/C disc and field coil and pulley mounting surfaces. 2. CAUTION: Do not use air tools. The A/C clutch field coil can be easily damaged. Install the A/C clutch field coil. 1. Place the A/C clutch field coil on the A/C compressor with the A/C ...

Rear Wheel Bearing and Axle Shaft Oil Seal
Special Tool(s) Adapter for 303-224 205-153 (T80T-4000-W) Installer, Axle Shaft Bearing 205-124 (T78P-1225-A) Installer, Rear Axle Oil Seal 205-390 (T97T-1177-B) Remover, Axle Bearing 205-219 (T85L-1225-AH) S ...