Ford Mustang (1999-2004) Service Manual: Trim Panel - Quarter, Coupe
Removal and Installation
1. Remove the upper quarter trim panel. For additional information, refer to Trim Panel-Upper Quarter in this section.
2. Remove the scuff plate.

3. Remove the pin-type retainers.

4. Lower the rear seat backrests.
5. Remove the bolts and the rear seat backrest bolster.

6. Remove the quarter trim panel pin-type retainers.

7. Remove the lower quarter trim panel.
8. To install, reverse the removal procedure.
Trim Panel - Door
Removal
All vehicles
1. CAUTION: Use a shop towel or similar material between the
tool and the front door
trim panel or damage to the front door trim panel may occur.
Position the window re ...
Trim Panel - Quarter, Convertible
Special Tool(s)
Safety Belt Bolt Bit
501-010 (T77L-2100-A)
Removal and Installation
1. Lower the convertible top to the full down position.
2. Remove the rear seat cushion.
3. ...
Other materials:
Coupling
Removal and Installation
1. CAUTION: Do not allow the steering column shaft to rotate while
intermediate shaft
is disconnected or damage to the clockspring can result. If there is evidence
that the
steering column shaft has rotated the clockspring must be re ...
Bypass Tube - 3.8L
Material
Item
Specification
Motorcraft Premium Gold
Engine Coolant
VC-7-A (in Oregon VC-7-B)
(yellow color)
WSS-M97B51-
A1
Removal and Installation
1. Drain the engine coolant. For additional information, refer to Cooling
System Dra ...
Connecting Rod - Bearing Journal Clearance
Special Tool(s)
Plastigage
303-D031 (D81L-6002-B) or
equivalent
NOTE: The crankshaft connecting rod journals must be within
specifications to check the connecting
rod bearing journal clearance.
1. Remove the connecting rod bearing cap.
2. ...
