Ford Mustang (1999-2004) Service Manual: Oil Pan Baffle
Removal and Installation
1. Remove the oil pump screen cover and tube (6622). For additional information, refer to Oil Pump Screen and Pickup Tube in this section.
2. Remove the oil pan baffle (6687).
- Remove the nuts.

3. To install, reverse the removal procedure.
Installation
1. NOTE: If the oil pan is not secured within four minutes, the
sealant must be removed and the
sealing area cleaned with metal surface cleaner. Allow to dry until there is
no sign of wetness,
o ...
Other materials:
Powertrain Control Module (PCM)
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the RH front door scuff plate.
3. Remove the RH cowl side trim panel.
Remove the pin-type retainer.
Remove the panel.
4. Disconnect ...
Wheel Hub or Axle Flange Face Runout
NOTE: If the axle shaft assembly is removed, check runout of the shaft
itself. The forged (unmachined)
part of the shaft is allowed to have as much as 3.0 mm (0.120 inch) runout. This
alone will not cause a
vibration condition.
1. Position the special tool ...
Motor - Windshield Wiper
Removal
CAUTION: The internal permanent magnets used in the windshield
wiper motor are made
of a glass-like material. To avoid damaging the magnets, do not strike
the motor with a hammer
or any other object.
NOTE: The windshield wiper motor is n ...
