Ford Mustang (1999-2004) Service Manual: Rear Window Glass
Special Tool(s)
 |
Rotunda Pneumatic Knife with Offset Blade 107-R1511 or equivalent |
 |
The Pumper 164-R2459 or equivalent |
 |
Rotunda Interior Auto Glass Cut-Out Knife Kit 164-R2450 or equivalent |
Switch - Window Regulator Control
Removal
1. CAUTION: Use a shop towel or similar material between the
tool and the door trim
panel or damage to the door trim panel may occur.
Position the window regulator switch plate aside. ...
Removal
Convertible
1. For removal of the back window glass, refer to Section.
Coupe
WARNING: To prevent glass splinters from entering eyes or
cutting hands, wear safety
glasses and heavy gloves wh ...
Other materials:
Synchronizers
Disassembly
NOTE: This procedure applies to all synchronizer assemblies
(7124). The synchronizers are slightly
different in design. Notation is made where procedural differences occur.
1. On the third/fourth speed synchronizer and the fifth speed
synchr ...
Evaporator Core Orifice
NOTE: The evaporator core orifice is an integral part of the condenser
to evaporator line and should
be installed as an assembly with the line.
NOTE: A new evaporator core orifice should be installed whenever a new
A/C compressor is installed.
The evapora ...
Engine (Disassembly)
Special Tool(s)
Impact Slide Hammer
100-001 (T50T-100-A)
Remover, Crankshaft Rear Oil
Slinger
303-514 (T95P-6701-AH)
Remover, Crankshaft Rear Oil
Seal
303-519 (T95P-6701-EH)
Remover, Crankshaft Vibration ...
