Ford Mustang (1999-2004) Service Manual: Restraints Control Module (RCM)
Special Tool(s)
![]() |
Diagnostic Tool, Restraint System (2 Req'd) 418-F088 (105-R0012) |
Weld Nut Repair - Stripped Weld Nut, Restraints
Control
Module (RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint ...
Removal
WARNING: The restraints control module (RCM) orientation is critical
for proper system
operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) has been
involved in a col ...
Other materials:
Exhaust Gas Recirculation (EGR) Vacuum Regulator
Solenoid
Mach I vehicles
1. Remove the air intake scoop. For additional information, refer to
Section .
All vehicles
2. Remove the exhaust gas recirculation (EGR) vacuum regulator solenoid.
Disconnect the electrical connector.
Remove the bolts.
3. To ins ...
Brake Pads - Cobra
Removal
1. Remove brake fluid in the master cylinder reservoir until the
reservoir is half full.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.
4. CAUTION: Install new pads if worn to or past the specified
thi ...
Installation
1. CAUTION: Make sure the hardened washer is installed between the
lower
suspension arm and bushing and the shock absorber. Failure to do so can result
in
damage and failure of the lower suspension arm and bushing.
NOTE: The toe link bolt and nuts are of a ...

