Ford Mustang (1999-2004) Service Manual: Seat - Front Power
Removal and Installation
1. Remove the safety belt through the opening in the safety belt guide.
2. Move the seat forward.
3. Remove the bolt covers and remove the seat track bolts.
4. Move the seat rearward.
5. Remove the seat track nuts.
6. Move the seat forward.
7. Disconnect the battery.
8. Disconnect the power seat electrical connector.
9. Remove the power seat.
10. To install, reverse the removal procedure.
Lumbar Assembly
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Release the J-clip.
3. Remove the seat backrest latch ...
Seat Track
Removal and Installation
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Remove the outboard seat trim shield.
3. Disconnect the electrical c ...
Other materials:
Inspection and Verification
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid having scalding hot coolant ...
Pinion Seal
Special Tool(s)
Installer, Drive Pinion Oil Seal
205-133 (T79P-4676-A)
Removal
1. Remove the pinion flange (4851). For additional information, refer to
Drive Pinion Flange in this
section.
2. Force up the metal flange of the rear axle drive p ...
Component Tests
Grid Wire Test
1. Using a bright lamp inside the vehicle, inspect the wire grid from
the exterior. A broken grid wire
will appear as a brown spot.
2. Run the engine at idle. Set the rear window defrost switch to ON. The
indicator light should
co ...
