Ford Mustang (1999-2004) Service Manual: Selector Plate
Transmission (Disassembly)
Special Tool(s)
Bearing Puller
205-D064 (D84L-1123-A) or
Equivalent
Front Hub Tool
204-069 (T81P-1104-C)
Holding Fixture
307-003 (T57L-500-B)
Imp ...
Disassembly
1. NOTE: Mark the position of each gear shifter fork (7230).
Place the gear shift plates (7N232) and the gear selector interlock sleeve
(7K201) in the neutral
position to center the gear shift pl ...
Other materials:
Cylinder Head - Distortion
Special Tool(s)
Straight Edge
303-D039 (D83L-4201-A) or
equivalent
1. Use a straight edge and a feeler gauge to inspect the cylinder head for
flatness. If the cylinder
head is distorted, install a new cylinder head.
Cylinder Bore -Cleaning ...
Starter Drive and Flywheel Ring Gear Inspection
1. Remove the starter motor. For additional information, refer to Starter
Motor-3.8L or Starter
Motor-4.6L in this section.
2. Check the wear patterns on the starter drive gear and the flywheel ring
gear . If the wear pattern
is normal, install the sta ...
Caliper
1. NOTE: It is not necessary to do a complete brake system
bleed if only the disc brake caliper
(2B120) was disconnected.
Place a box end wrench on the disc brake caliper bleeder screw (2208).
Attach a rubber drain
tube to the disc brake caliper b ...
