Ford Mustang (1999-2004) Service Manual: Spring
Special Tool(s)
![]() |
Tie-Rod End Remover 211-001 (TOOL-3290-D) or Equivalent |
![]() |
Coil Spring Compressor 204-D001 (D78P-5310-A) or Equivalent |
Shock Absorber
Removal
WARNING: All vehicles are equipped with gas pressurized shock absorbers
which will
extend unassisted. Do not apply heat or flame to the shock absorbers during
removal or
component servicing. ...
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part ...
Other materials:
Installation
1. Lubricate the lip of the wheel bearing oil seal
Use Premium Long-Life Grease XG-1-C or equivalent meeting Ford
specification ESAM1C75-
B.
2. CAUTION: Do not damage the wheel bearing oil seal.
Install the two axle shafts.
3. CAUTION: Do not damage th ...
Water Pump
Removal and Installation
1. Disconnect the battery ground cable.
2. Drain the coolant. For additional information, refer to Supercharger Cooling
System Draining,
Filling and Bleeding in this section.
3. Remove the retainer and position the inner fender well ...
Using snow chains
WARNING: Driving too fast for conditions creates the possibility
of loss of vehicle control. Driving at very high speeds for
extended periods of time may result in damage to vehicle components.
WARNING: Snow tires must be the same size, load index, speed
ratin ...


