Ford Mustang (1999-2004) Service Manual: Wheel Studs

Removal

1. Remove the wheel hub (1104). For additional information, refer to Wheel Hub and Bearing in this section.

2. Using a press, remove the wheel stud (1107) from the wheel hub.

Wheel Studs

Installation

1. Using a press, install a new wheel stud.

Wheel Studs

2. Install the wheel hub. For additional information, refer to Wheel Hub and Bearing in this section.

    Front Suspension
    Torque Specifications ...

    Wheel Hub and Bearing
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...

    Other materials:

    Pinion Seal
    Special Tool(s) Installer, Drive Pinion Oil Seal 205-133 (T79P-4676-A) Removal 1. Remove the pinion flange (4851). For additional information, refer to Drive Pinion Flange in this section. 2. Force up the metal flange of the rear axle drive p ...

    Generator - 3.8L
    Removal and Installation 1. Disconnect the battery (10655). For additional information, refer to Section. 2. Relieve the accessory drive belt (8620) tension and remove the belt from the generator pulley. Leave the belt in place for reinstallation ...

    Manual transmission
    Using the Clutch Manual transmission vehicles have a starter interlock that prevents starting the engine unless the clutch pedal is fully pressed. To start the vehicle: 1. Make sure the parking brake is fully set. 2. Press the clutch pedal to the floor, then ...