Ford Mustang (1999-2004) Service Manual: Brake System (Description and Operation)

Component Locations

Brake System+

 

Brake System

Brake System

The vehicle is equipped with a vacuum-assisted or a hydro-boost power braking system. The braking system is a front-to-rear split hydraulic system. The front wheel brakes utilize a dual piston brake caliper and disc brake system. The rear brakes utilize a single piston brake caliper and disc brake system. The parking brake system is a mechanical system that is controlled by an independent hand-operated parking brake control and is self-adjusting. A 4-wheel anti-lock brake system or anti-lock brake system with traction control (4WABS) is optional equipment on all models except Cobra. Cobra has ABS and traction control as standard equipment.

    Brake System - General Information
    Torque Specifications ...

    Brake System (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 60, Instrument Cluster for schematic and connector information. Refer to Wiring Diagrams Cell 97, Daytime Running Lamps for schematic and connector information. Special ...

    Other materials:

    General information
    WARNING: Driving while distracted can result in loss of vehicle control, accident and injury. Ford strongly recommends that drivers use extreme caution when using any device or feature that may take their focus off the road. Your primary responsibility is the ...

    Installation
    All vehicles CAUTION: After installing the urethane installed windshield, the vehicle should not be driven until the urethane adhesive has cured. The curing time at temperatures above 13C (55 F) and relative humidity above 50% is 12-24 hours (Refer ...

    Disassembly
    1. NOTE: The index mark on the output shaft must be aligned with the index mark on the output shaft ring gear during the assembly procedure. Remove the ring gear snap ring. 2. Separate the ring gear and output shaft. 3. Remove the three output shaft seal ...