Ford Mustang (1999-2004) Service Manual: Brake System
- Brake System - General Information
- Brake System (Description and Operation)
- Brake System (Diagnosis and Testing)
- Bleeding - Components
- Bleeding - System
- Runout Check - Brake Disc and Hub
- Front Disc Brake
- Front Disc Brake (Description and Operation)
- Pads
- Brake Pads - Cobra
- Caliper
- Brake Caliper - Cobra
- Brake Caliper Anchor Plate - Cobra
- Brake Caliper Anchor Plate
- Disc
- Shield
- Caliper (DISASSEMBLY AND ASSEMBLY)
- Rear Disc Brake
- Rear Disc Brake (Description and Operation)
- Caliper (Removal and Installation)
- Pads
- Disc
- Brake Caliper Support Bracket
- Shield
- Caliper (Disassembly and Assembly)
- Parking Brake and Actuation
- Parking Brake (Description and Operation)
- Parking Brake (Diagnosis and Testing)
- Parking Brake Cable Tension Release
- Parking Brake Control
- Cable and Conduit - Front
- Cable and Conduit
- Hydraulic Brake Actuation
- Hydraulic Brake Actuation (Description and Operation)
- Pedal and Bracket
- Master Cylinder
- Master Cylinder - Hydro-Boost
- Reservoir
- Control Valve
- Power Brake Actuation
- Brake Booster - Vacuum (Description and Operation)
- Brake Booster - Hydro-Boost (Description and Operation)
- Hydro-Boost Bleeding
- Brake Booster - Vacuum (Removal and Installation)
- Brake Booster - Hydro-Boost (Removal and Installation)
- Anti-Lock Control - Rear
- Anti-Lock Control - Traction Control
Halfshaft Joint
Special Tool(s)
Driver
205-199 (T83T-3132-A1)
Hub Bearing Cup Replacer
205-147 (T80T-4000-P)
Sensing Ring Replacer
206-041 (T89P-20202-A)
Disassembly
1. CAUTION: Do ...
Brake System - General Information
Torque Specifications
...
Other materials:
Brake Caliper Anchor Plate
Removal
1. Remove the pads. For additional information, refer to Pads in this
section.
2. Remove the anchor plate (2B292).
1. Remove and discard the anchor plate bolts.
2. Remove the anchor plate.
Installation
1. CAUTION: Use correct t ...
Speed Control
Torque Specifications
Speed Control
The speed control system consists of the following components:
speed control actuator cable (9A825)
deactivator switch
output shaft sensor (OSS)
speed control actuator switches (9C888)
brake pedal position (BPP) switc ...
Manual transmission
Using the Clutch
Manual transmission vehicles have a starter interlock that prevents
starting the engine unless the clutch pedal is fully pressed.
To start the vehicle:
1. Make sure the parking brake is fully set.
2. Press the clutch pedal to the
floor, then ...
