Ford Mustang (1999-2004) Service Manual: Crankshaft Rear Seal
Special Tool(s)
 |
Impact Slide Hammer 100-001 (T50T-100-A) |
 |
Remover, Crankshaft Rear Seal 303-519 (T95P-6701-EH) |
 |
Replacer, Rear Crankshaft Seal 303-516 (T95P-6701-BH) |
 |
Spacer, Rear Crank Seal Replacer 303-561 (T96T-6701-B) |
 |
Adapter, Crankshaft Rear Seal (Use only the adapter retaining bolts) 303-518 (T95P-6701-DH) |
 |
Adapter, Crankshaft Rear Seal (Use only the adapter and the center jack screw) 303-S560 (T96T-6701-A) |
Material
| Item | Specification |
| SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP or equivalent | WSS-M2C153- H |
Removal
1. Remove the flywheel or the flexplate. For additional information, refer to Flexplate in this section.
2. Using the special tools, remove the crankshaft rear seal.
Installation
1. Clean and inspect the mating surface.
2. NOTE: Lubricate the crankshaft rear seal lips with clean engine oil prior to installation.
Assemble the special tools and the crankshaft rear seal.
3. Install the special tools on the rear of the crankshaft.
4. Install the crankshaft rear seal. Tighten the center jack screw (303-S560) until the spacer (303- 561) contacts the engine block.
5. Install the flywheel or the flexplate. For additional information, refer to Flexplate in this section.
Flexplate
Removal and Installation
1. Remove the transmission.
2. Remove the six bolts retaining the flexplate to crankshaft, and remove
the flexplate.
3. To install, reverse the removal procedure. ...
Engine Support Insulators
Special Tool(s)
3 Bar Engine Support Kit
303-F072
Engine Lift Bracket Set
303-D095 (D94L-6001-A) or
equivalent
...
Other materials:
Auxiliary input jack
WARNING: Driving while distracted can result in loss of vehicle
control, crash and injury. We strongly recommend that you use
extreme caution when using any device that may take your focus off
the road. Your primary responsibility is the safe operation of your ...
Camshaft End Play - OHC Engines
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
1. Remove the roller followers. Refer to the appropriate section in Group 303
for the procedure.
2. Use a Dial Indicator Gauge with Holding Fixt ...
Removal
All vehicles
1. Remove the air intake scoop. For additional information, refer to Section.
2. Remove the Hydro-Boost brake booster. For additional information, refer to
Section..
3. Raise and support the vehicle. For additional information, refer to Section ...
