Ford Mustang (2005-2014) Owners Manual: Fuel and Refueling
- Safety precautions
- Fuel quality
- Running out of fuel
- Refueling
- Fuel consumption
- Emission control system
- On-board Diagnostics (OBD-II)
Engine block heater
WARNING: Failure to follow engine block heater instructions
could result in property damage or physical injury.
WARNING: Do not use your heater with ungrounded electrical
systems or two-pronged (cheat ...
Safety precautions
WARNING: Do not overfill the fuel tank. The pressure in an
overfilled tank may cause leakage and lead to fuel spray and fire.
WARNING: The fuel system may be under pressure. If you hear
a hissing soun ...
Other materials:
Installation
1. Install the intake manifold and gaskets, tighten the bolts in the sequence
shown.
2. NOTE: The O-ring is to be installed on the top of the thermostat.
Install the water thermostat and the O-ring.
Install a new O-ring as necessary.
3. Install the wa ...
Communication Circuit Wiring Repair
Special Tool(s)
Heat Gun
107-R0300 or equivalent
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Strip the wires.
3. NOTE: Use rosin core mildly activated (RMA) solder, not acid core
solder.
Solder ...
Push Rods - Inspection
1. CAUTION: Do not attempt to straighten push rods.
Check the ends of the push rods for nicks, grooves, roughness or
excessive wear. Install new
push rods as necessary. Refer to the appropriate section in Group 303 for
the procedure.
The push rods ca ...
