Ford Mustang (1999-2004) Service Manual: Brake Caliper Anchor Plate - Cobra
Removal
1. Remove the pads. For additional information, refer to Brake Pads-Cobra in this section.
2. Remove the anchor plate bolts.
Installation
1. Follow the removal procedure in reverse order.
Brake Caliper - Cobra
Removal
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the caliper locating pin E-clip.
4. Remove the caliper locating pin.
5. Remove the front brake ...
Brake Caliper Anchor Plate
Removal
1. Remove the pads. For additional information, refer to Pads in this
section.
2. Remove the anchor plate (2B292).
1. Remove and discard the anchor plate bolts.
2. Remove the ...
Other materials:
Idle Air Control (IAC) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional
information, refer to Section.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the bolts, the IAC valve and the gasket.
4. NOTE: Install a new ga ...
Reverse Servo Assembly
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C)
Remover/Installer, Servo
Piston
307-251 (T92P-70023-A)
Installer, Servo Piston
307-073 (T80L-77030-A)
Removal
1. Remove the main co ...
Seal
Special Tool(s)
Installer, Transmission
Extension Housing Oil Seal
308-227 (T94P-7657-A)
Slide Hammer
100-001 (T50T-100-A)
Remover, Bushing
307-001 (TOOL-1175-AC) or
Equivalent
Removal
1. With the vehicle in NEU ...
