Ford Mustang (2005-2014) Owners Manual: Parking brake
WARNING: If the parking brake is fully released, but the brake warning lamp remains illuminated, the brakes may not be working properly. See your authorized dealer as soon as possible.
WARNING: Always set the parking brake fully and make sure that the transmission selector lever is securely latched in position P (automatic transmission) or position 1 (manual transmission).
To set the parking brake, pull the parking brake handle up as far as possible.
To release the parking brake:
1. Press and hold the button located at the end of the parking brake
handle.
2. Pull the handle up slightly, then push the handle down.
Hints on driving with anti-lock brakes
When the system is operating, the brake pedal will pulse and may travel
further. Maintain pressure on the brake pedal. You may also hear a noise
from the system. This is normal.
The anti-lock braking ...
Traction Control
PRINCIPLES OF OPERATION
The traction control system helps avoid drive wheel spin and loss of
traction.
If your vehicle begins to slide, the system applies the brakes to individual
wheels and, when ne ...
Other materials:
Turn Signal and Hazard Lamps
Refer to Wiring Diagrams Cell 90 , Turn/Stop/Hazard Lamps for schematic
and connector information.
Special Tool(s)
73 III Automotive Meter
105-R0057 or equivalent
Inspection and Verification
1. Verify the customer concern.
2. Visually ins ...
Installation
1. Align the center mark on the cover assembly to the V-notch on the rear
glass assembly and
staple the entire length of the number four bow.
2. Center the listing sleeve on the bottom of the folding top number two bow.
3. Position the listing sleeve onto ...
Handle - Exterior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Release the exterior door handle actuating rod by opening the clip.
3. Remove the exterior door handle nuts.
4. Remove the exterior door handle.
Ins ...
