Ford Mustang (1999-2004) Service Manual: Safety Belt Buckle - Rear Seat
Removal
1. Remove the rear seat cushion.
2. Remove the bolt and the safety belt buckle.
Installation
1. NOTE: LH and RH rear seat safety belt buckles have different anchor plates. Make sure correct part is used when installing buckle and anchor plate in the anchor locator feature.
NOTE: LH rear seat safety belt buckle anchor plate shown.
To install, reverse the removal procedure.
2. Make sure the safety belt buckles are routed correctly and are placed through the seat cushion.
3. Check the restraint system for correct operation.
Child Safety Seat Tether Anchor -LATCH
Removal and Installation
1. Remove the lower anchors and tethers for children (LATCH) attachment fasteners.
2. Remove the LATCH attachment.
3. To install, reverse the removal procedure.
Safety Belt Buckle - Front Seat
Removal
Driver and passenger seat
1. Remove the front seat. For additional information, refer to Section.
2. Remove the nut and the safety belt buckle.
Driver seat only
3. Disconnect the safety bel ...
Supplemental Restraint System
Torque Specifications
...
Other materials:
Chuckle
Chuckle that occurs on the coast driving phase is usually caused by excessive
clearance between the
differential gear hub and the differential case bore.
Damage to a gear tooth on the coast side can cause a noise identical to a
chuckle. A very small tooth
n ...
Disassembly
Initial disassembly
1. Remove the differential housing cover (4033) and drain the lubricant into
a suitable container.
2. Wipe the lubricant from the internal working parts and inspect the parts for
wear and damage.
3. Using the special tool, measure and n ...
Cleaning the interior
WARNING: Do not use cleaning solvents, bleach or dye on the
vehicle’s safety belts, as these actions may weaken the belt
webbing.
WARNING: On vehicles equipped with seat-mounted airbags, do
not use chemical solvents or strong detergents. Such products
could ...
