Ford Mustang (1999-2004) Service Manual: Safety Belt Buckle - Front Seat
Removal
Driver and passenger seat
1. Remove the front seat. For additional information, refer to Section.
2. Remove the nut and the safety belt buckle.
Driver seat only
3. Disconnect the safety belt buckle electrical connector.
Installation
1. To install, reverse the removal procedure.
2. Check the restraint system for correct operation.
Child Safety Seat Belt - Tether Anchor
Removal and Installation
Hard top only
1. Remove the package tray. For additional information, refer to Section.
2. Remove the bolts and the tether anchor bracket.
Convertible only
3. NOTE: Rework ...
Safety Belt Buckle - Rear Seat
Removal
1. Remove the rear seat cushion.
2. Remove the bolt and the safety belt buckle.
Installation
1. NOTE: LH and RH rear seat safety belt buckles have different anchor
plates. Make sure correc ...
Other materials:
Fuel cut-off switch
WARNING: Failure to inspect and if necessary repair fuel leaks
after a collision may increase the risk of fire and serious injury.
Ford Motor Company recommends that the fuel system be inspected by
an authorized dealer after any collision.
In the event of a m ...
Master Cylinder Priming - In-Vehicle or Bench
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid
contact with
eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush
eyes with
running water for 15 minutes. Get medical attention if irritation persists. If
take ...
Installation
1. Install the upper arm and bushing to the mounting bracket.
1. Position the arm and bushing.
2. Install a new nut and bolt. Do not tighten at this time.
2. Connect the upper arm and bushing to the axle.
1. Position the arm and bushing.
2. Install a ...
