Ford Mustang (1999-2004) Service Manual: Supercharger Belt

Accessory Drive Belt - 4.6L (2V) and (4V)

Removal and Installation Mach I 1. Remove the air intake scoop. For additional information, refer to Section. Cobra 2. Remove the supercharger drive belt cover. 3. Rotate the supercharger belt tensi ...

Accessory Drive Belt Tensioner - 3.8L

Removal and Installation 1. Remove the drive belt. For additional information, refer to Accessory Drive Belt-3.8L in this section. 2. Remove the belt tensioner. Remove the bolt. 3. To install, ...

Other materials:

Push Rods - Inspection
1. CAUTION: Do not attempt to straighten push rods. Check the ends of the push rods for nicks, grooves, roughness or excessive wear. Install new push rods as necessary. Refer to the appropriate section in Group 303 for the procedure. The push rods ca ...

Accelerator Cable Bracket - Supercharged Engine
Removal and Installation 1. Disconnect the accelerator cable and speed control cable. 2. Depress the tabs and disconnect the accelerator cable and speed control cable from the accelerator cable bracket 3. Remove the bolts and the accelerator cable bracket ...

Output Shaft Speed (OSS) Sensor
Removal and Installation 1. With the vehicle in NEUTRAL, raise and support the vehicle. 2. Disconnect the electrical connector. 3. Remove the output shaft speed (OSS) sensor. 4. To install, reverse the removal procedure. ...