Ford Mustang (2005-2014) Owners Manual: Auxiliary Power Points

WARNING: Do not plug optional electrical accessories into the cigarette lighter socket (if equipped). Improper use of the lighter can cause damage not covered by your warranty, and can result in fire or serious injury.

Note: If used when the engine is not running, the battery will discharge.

There may be insufficient power to restart your engine.

Note: Do not insert objects other than an accessory plug into the power point. This will damage the outlet and blow the fuse.

Note: Do not hang any type of accessory or accessory bracket from the plug.

Note: Do not use the power point over the vehicle capacity of 12 volt DC 180 watts or a fuse may blow.

Note: Do not use the power point for operating a cigarette lighter element.

Note: Improper use of the power outlet can cause damage not covered by your warranty.

Note: Always keep the power point caps closed when not in use.

Run the engine for full capacity use of the power point. To prevent the battery from being discharged:

• Do not use the power point longer than necessary when the engine is not running.
• Do not leave devices plugged in overnight or when the vehicle is parked for extended periods.

Locations

Power points may be found:

• on the instrument panel
• in the center console storage compartment.

    HomeLink® wireless control system
    WARNING: Make sure that the garage door and security device are free from obstruction when you are programming. Do not program the system with the vehicle in the garage. WARNING: Do not use the system ...

    Storage Compartments
    CENTER CONSOLE Stow items in the cupholder carefully as items may become loose during hard braking, acceleration or collisions, including hot drinks which may spill. Available console features includ ...

    Other materials:

    Jacking
    WARNING: Never run the engine with one wheel off the ground, such as when changing a tire. The wheel still on the ground could cause the vehicle to move. CAUTION: The jack (17080) provided with the vehicle is intended to be used in an emergency for changing ...

    Master Cylinder
    Removal 1. Disconnect the fluid level sensor connector. 2. Disconnect the brake tubes. 3. Remove the brake master cylinder nuts. 4. Remove the brake master cylinder (2140). Installation 1. To install, reverse the removal procedure. Bleed the brake ...

    Windshield wipers
    Note: Fully defrost the windshield before switching on the windshield wipers. Note: Make sure you switch off the windshield wipers before entering a car wash. Note: Clean the windshield and wiper blades if they begin to leave streaks or smears. If that does ...