Ford Mustang (1999-2004) Service Manual: Jacking

WARNING: Never run the engine with one wheel off the ground, such as when changing a tire. The wheel still on the ground could cause the vehicle to move.

CAUTION: The jack (17080) provided with the vehicle is intended to be used in an emergency for changing a deflated tire. To avoid damage to the vehicle, never use the jack to lift the vehicle for any other purpose. Refer to the Owner Guide when using the jack supplied with the vehicle.

CAUTION: Under no circumstances should the vehicle ever be lifted by the suspension arm brackets, rear stabilizer or differential housing or convertible cross brace. Severe damage to the vehicle could result.

CAUTION: Do not attempt to use jack pressure on either the front bumper (17757) or the rear bumper (17906) of any vehicle. Damage to the bumper covers will occur.

Lift the vehicle using the Jacking Points procedure in this section.

Jacking Points

Jacking Points

To lift the front or either side of the front end, position the floor jack under the front frame lift points.

Jacking Points

To lift the rear or either side of the rear end, position the floor jack under the rear lift points.

    Lifting
    CAUTION: Do not allow the lift adapters to contact the steering linkage, suspension arms, stabilizer arms, or to compress the lower suspension arm stabilizer bar insulator (5493). Damage to the sus ...

    Other materials:

    Crankshaft Position (CKP) Sensor - 4.6L
    Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the A/C compressor. For additional information, refer to Section. 3. Remove the crankshaft position (CKP) sensor. Disconnect the connect ...

    Safety belt-minder
    This feature supplements the safety belt warning function by providing additional reminders by intermittently sounding a chime and illuminating the safety belt warning light when the driver’s or front passenger’s seat is occupied and the safety belt is unb ...

    Installation
    1. Using the special tools, install the new intake valve stem seals. 2. Using the special tools, install the new exhaust valve stem seals. 3. Install the Valve Spring Compressor Spacer between the valve spring coils to protect the intake valve stem seal f ...