Ford Mustang (1999-2004) Service Manual: Brake Caliper - Cobra
Removal
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the caliper locating pin E-clip.
4. Remove the caliper locating pin.
5. Remove the front brake flow bolt.
6. Remove the caliper.
7. Remove the brake pads.
Installation
1. NOTE: Use new copper washers on front brake flow bolt.
Follow the removal procedure in reverse order.
- Bleed the caliper.
Installation
1. Make sure the anti-rattle spring is correctly positioned in the caliper. 2. CAUTION: Make sure guide pin boots are correctly seated or damage to guide pins can occur. Install the disc brake c ...Brake Caliper Anchor Plate - Cobra
Removal 1. Remove the pads. For additional information, refer to Brake Pads-Cobra in this section. 2. Remove the anchor plate bolts. Installation 1. Follow the removal procedure in reverse ...Other materials:
General information on radio frequencies
This device complies with part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interferen ...
Pressure
1. Clean all dirt from and remove the brake master cylinder filler
cap and fill the brake master
cylinder reservoir with the specified brake fluid.
2. NOTE: Master cylinder pressure bleeder adapter tools are available
from various manufacturers
of pres ...
Pinpoint Tests
The pinpoint tests are a step-by-step diagnostic process designed to
determine the cause of a condition. It may not always be necessary to follow a
pinpoint test to its conclusion. Carry out only the
steps necessary to correct the condition. Then, test the s ...