Ford Mustang (1999-2004) Service Manual: Camshaft
Material
Removal
1. Remove the valve tappets. For additional information, refer to Valve Tappets in this section.
2. Remove the timing chain. For additional information, refer to Timing Chain in this section.
3. Position the wire harness aside.
4. Remove the radiator fan and shroud assembly.
5. Remove the engine balance shaft drive gear from the camshaft.
1. Remove the camshaft key.
2. Remove the engine balance shaft drive gear.
6. Remove the camshaft.
1. Remove the bolts.
2. Remove the camshaft thrust plate.
3. Remove the spacer.
4. Remove the camshaft.
Installation
1. NOTE: Lubricate the camshaft with clean engine oil prior to installation.
To install, reverse the removal procedure.
Valve Tappets
Material Removal CAUTION: If removing more than one valve tappet, mark the components removed for correct location. 1. Remove the lower intake manifold. For additional information, refer to Lo ...Engine Dynamic Balance Shaft
Removal 1. Remove the timing chain (6268). For additional information, refer to Timing Chain in this section. 2. Disconnect and position the wire harness aside. 3. Remove the radiator fan and ...Other materials:
Door Speaker - Upper
Removal and Installation
1. Remove the front door trim panels (239420). For additional
information, refer to Section
2. Remove the upper speaker access cover.
3. Remove the upper speaker housing.
1. Remove the screw.
2. Remove the upper spea ...
Inspection and Verification
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid having scalding hot coolant ...
Transmission (Installation)
Material
Item
Specification
DEXRON III (ATF)
Transmission Fluid
XT-2-QDX or equivalent
DEXRON III
Pipe Sealant with Teflon
D8AZ-19554-A or equivalent
WSK-M2G350-
A2
Premium Long Life Grease
XG-1-C, K or T or equivalent
...