Ford Mustang (1999-2004) Service Manual: Engine Dynamic Balance Shaft
Removal
1. Remove the timing chain (6268). For additional information, refer to Timing Chain in this section.
2. Disconnect and position the wire harness aside.
3. Remove the radiator fan and shroud assembly (8146).
4. Remove the engine dynamic balance shaft (6A311).
- Remove the bolts.
- Remove the balance shaft driver gear, thrust plate and engine dynamic balance shaft as an assembly.
Installation
1. Turn the camshaft so that the timing mark is at 12 o'clock and install the engine dynamic balance shaft assembly into the cylinder block (6010). Turn the engine balance shaft driven gear so that the timing mark lines up with the timing mark on the engine balance shaft drive gear (6A303).
2. NOTE: If correctly aligned, the engine dynamic balance shaft keyway will be at 12 o'clock and the camshaft keyway will be at 6 o'clock on the camshaft.
Install the bolts.
3. Install the radiator fan and shroud assembly.
4. Connect the connector and install the pin-type retainer.
5. Install the timing chain. For additional information, refer to Timing Chain in this section.
Camshaft
Material Removal 1. Remove the valve tappets. For additional information, refer to Valve Tappets in this section. 2. Remove the timing chain. For additional information, refer to Timing Chain ...Timing Chain
Removal 1. Remove the timing cover. For additional information, refer to Engine Front Cover in this section. 2. Remove the camshaft position sensor drive gear. 1. Remove the bolt. 2. Remov ...Other materials:
Air Conditioning (A/C) System Check - Retail Procedure
NOTE: This Retail Procedure is not eligible for claiming on Ford
paid repairs (warranty and ESP).
NOTE: The engine should be run at idle for 10 minutes with the air
conditioning on and set to MAX A/C
before carrying out this retail procedure.
NOTE: Re ...
Wheel Studs
Removal
1. Remove the wheel hub (1104). For additional information, refer to Wheel
Hub and Bearing in
this section.
2. Using a press, remove the wheel stud (1107) from the wheel hub.
Installation
1. Using a press, install a new wheel stud.
2. Install the w ...
Glass, Frames and Mechanisms (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 100 , Power Windows for schematic and
connector information.
Refer to Wiring Diagrams Cell 56 , Rear Window Defrost for schematic and
connector information.
Special Tool(s)
Worldwide Diagnostic System
(WDS)
4 ...