Ford Mustang (1999-2004) Service Manual: Condenser Core
Material
Item | Specification |
PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) | WSH-M1C231- B |
Removal and Installation
NOTE: If an A/C condenser core leak is suspected, the A/C condenser core must be leak tested before it is removed from the vehicle. For additional information, refer to Section.
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Recover the refrigerant. For additional information, refer to Section.
2. Remove the pin-type retainers and remove the upper radiator sight shield.
3. Remove the air cleaner and air cleaner outlet tube. For additional information, refer to Section.
4.6L (2V), 4.6L (4V) vehicles
4. Remove the bolts and position the coolant bottle aside.
4.6L (4V) vehicles
5. Remove the bolts and position the coolant bottle aside.
3.8L vehicles
6. Remove the bolts.
7. Remove the bracket and the coolant bottle.
All vehicles
8. Remove the nuts and disconnect the lines.
- Discard the O-ring seals.
Vehicles with 4WABS
9. Remove the hydraulic control unit upper bracket bolts.
10. Raise the vehicle.
11. Remove the hydraulic control unit lower bracket bolt and position the hydraulic control unit aside.
12. Lower the vehicle.
All vehicles
13. Remove the bolts and the radiator brackets.
14. Position the radiator rearward.
15. Remove the pin-type retainers.
16. Position the wiring harness rearward.
17. Remove the condenser bolts.
18. Remove the condenser core.
19. To install, reverse the removal procedure.
- Install new O-ring seals lubricated in clean PAG oil.
- Lubricate the refrigerant system with the correct amount of clean PAG oil. For additional information, refer to Section.
20. Evacuate, leak test and charge the refrigerant system. For additional information, refer to Section.
Air Conditioning (A/C) Pressure Relief Valve - 4.6L
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation NOTE: Installation of a ...Compressor Manifold and Tube Assembly - 3.8L
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation NOTE: Installation of a ...Other materials:
Frame and Mounting
Frame and Body Mounting
Torque Specifications
Frame Assembly
Underbody misalignment can affect front and rear wheel alignment, the
operation of the suspension
parts and drivetrain operation. Window glass cracks, door and window opening
concerns, and air or ...
Instrument Cluster (Description and Operation)
The instrument cluster (10849) consists of the following components:
Instrument Cluster-Base 3.8L Engine
Instrument Cluster-Base 4.6L Engine
Instrument Cluster-Cobra
...
Installation
1. CAUTION: Timing chain procedures must be followed exactly or damage
to the
pistons or valves will result.
Compress the tensioner plunger, using a soft-jawed vise.
2. Install a retaining clip on the tensioner to hold the plunger in during
installation.
...