Ford Mustang (1999-2004) Service Manual: Convertible Top Material

Installation

1. Overlay the new rear window glass assembly over the old rear window glass assembly and transpose the markings with a grease pencil. 2. Center the V-notch on the new rear window glass assemb ...

Removal

1. Remove the rear exterior trim mouldings. 2. Remove the clips 3. Remove the 13 Torx screws and the seal compression panel. 4. Remove the staples. 5. Remove the staples from the number one b ...

Other materials:

Engine Ignition (Description and Operation)
The ignition coil (12029), which is mounted on the upper intake manifold, can be described as a coil pack containing three separate coil units. Each coil unit is individually controlled by the powertrain control module (PCM) (12A650) through separate wire le ...

Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts. Install a new driveshaft bearing retainer circlip. 2. Remove the special tool. 3. CAUTION: Differential seal damage will occur if installing the halfshaft without the special tool installed. ...

Countershaft
Special Tool(s) Plate, Bearing Oil Seal 205-090 (T75L-1165-B) Puller, Bearing 205-D064 (D84L-1123-A) Installer, Drive Pinion Bearing Cone 205-004 (T53T-4621-B) Remover/Installer, Bearing Tube 308-025 ( ...