Ford Mustang (1999-2004) Service Manual: Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information refer to Section.
2. Disconnect the cylinder head temperature sensor connector.
3. Remove the CHT sensor.
Installation
1. To install, reverse the removal procedure.
Idle Air Control (IAC) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional
information, refer to Section.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the bolt ...
Engine Coolant Temperature (ECT) Sensor - 4.6L (2V)
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Partially drain the cooling system. For additional information, refer
to Section.
3. Disc ...
Other materials:
Assembly
Initial assembly
1. Coat the new differential drive pinion bearing cup(s) with lubricant.
Use SAE 75W-140 High Performance Rear Axle Lubricant F1TZ-19580-B or
equivalent
meeting Ford specification WSL-M2C192-A.
2. Using the special tool, install the diff ...
Fuel Injectors
Material
Item
Specification
SAE 5W-20 Premium Synthetic
Blend Motor Oil
XO-5W20-QSP or equivalent
WSS-M2C153-
H
Removal and Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near ...
Introduction
ABOUT THIS MANUAL
Thank you for choosing Ford. We recommend that you take some time
to get to know your vehicle by reading this manual. The more that you
know about it, the greater the safety and pleasure you will get from
driving it.
WARNING: Always drive wit ...
